相关文章

板式家具生产线讲解开料机中步进电机参数关系到雕刻机的

板式家具生产线讲解开料机中步进电机参数关系到雕刻机的速度和精度

板式家具生产线的开料机中步进电机参数关系到雕刻机的速度和精度,一般情况下,设置步进驱动器的细分数,通常细分数越高,控制分辨率越高。

Plate furniture production line of the stepper motor parameters are related to the speed and accuracy of the engraving machine, in general, set the fine fraction of stepping drive, the higher the usual fine fraction, the higher the control resolution.

但细分数太高则影响到最大进给速度。对于用户可考虑脉冲当量为0.001mm/P(此时最大进给速度为9600mm/min)或者0.0005mm/P(此时最大进给速度为4800mm/min);对于精度要求不高的用户,脉冲当量可设置的大一些,如0.002mm/P(此时最大进给速度为19200mm/min)或0.005mm/P(此时最大进给速度为48000mm/min)。

But the fine fraction is too high to affect the maximum feed rate. For the user can consider the pulse equivalent to 0.001mm/P (at this time the maximum feed rate of 9600mm/min) or 0.0005mm/P (at this time the maximum feed rate of 4800mm/min); for the accuracy of the user, the pulse equivalent can be set up, such as 0.002mm/P (at this time the maximum feed rate is 19200mm/min) or 0.005mm/P (at this time the maximum feed rate is 48000mm/min).

For two-phase stepper motor, calculated as follows: pulse equivalent pulse equivalent = screw pitch, fine fraction, 200.

Setting of the takeoff speed of the stepping motor of the feeding machine. The so-called take off frequency is the stepping motor without acceleration, can directly start the work of the highest frequency.

合理地选取该参数能够提高加工效率,并且能避开步进电机运动特性不好的低速段;但是如果该参数选取大了,就会造成闷车,所以一定要留有余量。

It is reasonable to select the parameters that can improve the machining efficiency, and can avoid the low speed section of the stepping motor, but if the parameter is large, it will cause a boring car, so we must keep a margin.

在电机的出厂参数中,一般包含起跳频率参数。但是在机床装配好后,该值可能发生变化,一般要下降,特别是在做带负载运动时。所以,该设定参数最好是在参考电机出厂参数后,再实际测量决定。

In the factory parameters of the motor, the general parameters of the takeoff frequency are included. But after the machine tool is assembled, the value may change, generally to fall, especially when it is done with load. Therefore, the setting parameters of the reference motor factory parameters, and then the actual measurement decision.

更多关于定制家具生产线,数控排钻等新闻资讯敬请关注青岛欣大荣数控机器有限公司。